You may need to provide space for page marks by increasing
gutter measurements.
The variable mark
$[PagePositionNumber]
or
$[PPN]
can be
used to verify that the pages are in the correct page set
positions in the imposition.
Calibrate
When this check box is selected, the plate curve and print curve
are applied to the mark. The curves applied are the ones
selected in the
Plate Curve
list and
Print Curve
list in the
Calibration and Screening
section of the process template.
When this check box is cleared, only the plate curve is applied.
To prevent the application of the plate curve to a mark, select
%
%None%%
in the
Plate Curve
list in the
Calibration and
Screening
section of the process template.
Locate Page Marks Adjacent to
Select where to place the page marks in relation to the page's
trim box.
When you select
Right
or
Left
, the page marks rotate as
follows:
●
Left
—rotates the mark 90° counterclockwise
●
Right
—rotates the mark 90° clockwise
●
Bottom
—no rotation
●
Top
—no rotation
at Distance
(See
on page
.)
Determines where, relative to the edge, the mark is placed:
●
Sheet marks are placed relative to the plate edge. Depending
on the distance you type, you can place the sheet mark on
the press sheet or on the plate.
●
Page marks are placed relative to the finished page size (the
imposition hole).
CTLW Karat Output process template
617
