Important: Ensure the destination directory that you select has enough
space for PPF files generated by the PrintLink digital ink-profiling
software.
Rotation from CTP to Press
Adds rotation information to PPF files. Select
0°
,
90°
,
180°
,
270°
to rotate the plate the specified amount in a clockwise
direction.
Note: This option is set during Prinergy installation. Before you change
this option, contact a service representative.
File Generation Mode
Determines the format of the PPF files. Select one of the
following options in the list:
●
One file per sheet
to generate a combined PPF file that
contains information for the entire press sheet.
●
One file per surface
to generate a combined PPF file that
contains information for an entire surface.
●
One file per separation
to generate a separated PPF file—
that is, PrintLink generates a PPF file for each separation.
Press Interface
Specifies the press interface for which the PPF files are
intended. Select a specific type of press interface if you're using
one of the press interfaces listed; otherwise select
Generic
Press Interface
. If you selected
Generic Press Interface
, go to
the
Press Interface Configuration File
box to select a
configuration file. Note the number of divisions for the following
manual
Press Interface
options:
Press Interface option Number of divisions
Manual
100 divisions (0 to 100)
ManualHeidelberg
16 divisions, each with 16 subdivisions (1 to
16 : 1 to 16). For example, 50% is 8:16.
ManualHeidelberg1
24 divisions, each with 20 subdivisions (1 to
24 : 1 to 20)
ManualManroland
254 divisions (0 to 254)
ManualManRoland1
24 divisions (1 to 24)
Number of Ink Key Zones
Type the number of ink key zones.
576
Chapter 12—Outputs
