Line
list contains all ColorFlow plate lines controlled by the
selected plate setup in the selected snapshot.
When this option is selected, the
Color Setup
,
Device
, and
Device Condition
lists are not available.
This option is not available when a process template is
configured for continuous-tone (non-screened) output.
Plate Characterization
This halftone output mode supports imaging and measuring the
uncalibrated (or intrinsic) response of a plating line, such that a
plate linearization curve can be computed. When this option is
selected, no calibration curves are applied to input tints of any
separations.
When this option is selected, none of the lists in the
ColorFlow
section are available.
This option is not available when a process template is
configured for continuous-tone (non-screened) output.
Allow undefined color setup or color setup mismatch
This check box enables the job to run when the selected color
setup differs from the color setup assigned by the refine
process, or if the color setup has not been defined. Note that
when this feature is enabled, output could be significantly
different.
To use this feature, it is recommended to select an approved
color setup listed in the snapshot or by ID number. This will
ensure that the list of devices and device conditions are filtered
to include only those available in the selected color setup. Then,
the
Allow undefined color setup or color setup mismatch
check
box can be selected and output will succeed with a warning
message.
To output refined pages with no color setup assigned to them,
you can select the
Allow undefined color setup or color setup
mismatch
setting.
The list of devices and device conditions is unfiltered when
<Job_Color_Setup>
is selected. Note that this may cause
output to fail, if the device and device condition selected are not
in the job color setup. A message will be logged in the process
history, and you will need to either select a device and device
condition used in the job color setup or use the recommended
solution, as described above.
When
<Color_Setup_Assigned_by_Refine>
is selected, the list
of devices and device conditions is also unfiltered, and the
Final Output process template
547
