Select the
Descreen
check box to enable descreening.
Clear the
Descreen
check box to disable descreening.
Calibration Curve
Specifies a calibration curve from Harmony tonal calibration
software for the copydot files.
From the
Calibration Curve
box, select the calibration curve you
want Prinergy to use for copydot files.
Select
%%NONE%%
to disable this feature.
ColorFlow section of the final output process template
The
ColorFlow
section of the final output process template defines
how Prinergy applies ColorFlow settings during final output.
When you configure the ColorFlow settings in an output process
template, you select the device, device condition, and plate line, but not
a color setup. The color setup used is the one that was assigned to the
pages when they were refined—that is, either the color setup specified
in the refine process template that was used or the job's default color
setup. The color setup that is used during output processing is the
color setup specified for each page in the
Color Setup
column in the
Pages
pane.
WARNING: Output will fail if the color setup does not match the color setup
assigned during refine, unless the
Allow undefined color setup or color setup
mismatch
option is enabled.
It is possible to select from four modes for output to halftone devices
or files. These modes control the curves that are applied upon output.
Print Production
This halftone output mode reflects the standard operation of
Prinergy and ColorFlow for production. When this option is
selected, curves are applied to each output separation, as
described next:
●
The
print calibration curve
for the separation, determined by
the selections from the
Snapshot
,
Device
, and
Device
Condition
lists, and possibly modified at run time by the
settings in the Tonal Control dialog box, is applied to
separation input tints.
●
The
plate calibration curve
, determined by the selections from
the
Plate Setup
and
Plate Line
lists, is applied to the
separation tints modified by the print calibration curve.
Note: If
None
is selected from the
Plate Setup
and
Plate Line
lists, the
plate calibration curve is linear (has no effect).
ColorFlow section of the final output process template
545
