when this feature is enabled, output could be significantly
different.
To use this feature, it is recommended to select an approved
color setup listed in the snapshot or by ID number. This will
ensure that the list of devices and device conditions are filtered
to include only those available in the selected color setup. Then,
the
Allow undefined color setup or color setup mismatch
check
box can be selected and output will succeed with a warning
message.
To output refined pages with no color setup assigned to them,
you can select the
Allow undefined color setup or color setup
mismatch
setting.
The list of devices and device conditions is unfiltered when
<Job_Color_Setup>
is selected. Note that this may cause
output to fail, if the device and device condition selected are not
in the job color setup. A message will be logged in the process
history, and you will need to either select a device and device
condition used in the job color setup or use the recommended
solution, as described above.
When
<Color_Setup_Assigned_by_Refine>
is selected, the list
of devices and device conditions is also unfiltered, and the
Allow undefined color setup or color setup mismatch
check
box is grayed out and cannot be used. Note that this is the
default color setup setting for all process templates that were
upgraded from Prinergy Connect 5.1.
Snapshot
A ColorFlow snapshot captures the state of the entire color
database, making its elements available to the workflow and
providing a convenient backup. The snapshot feature makes it
unnecessary for you to manually save and name multiple
versions of your color control elements after adjusting them. At
any time, you can easily roll back (revert) to the state of a
previous snapshot in the ColorFlow software. If you roll back to
a previous snapshot, ColorFlow behaves as if changes after that
snapshot never happened.
When you have completed your work in ColorFlow to a certain
level and you are satisfied with the elements in color setups,
you will mark a snapshot as
approved
. By default in Prinergy
Connect, the currently approved snapshot is used. Only one
snapshot can be in the approved state at any time.
This list is not available if the
Plate Characterization
option is
selected.
Loose Page Output process template
437
