this plate setup, and the
Plate Line
list contains all ColorFlow
plate lines controlled by the plate setup in the selected
snapshot.
When this option is selected, the
Color Setup
list is not
available.
This option is not available when a process template is
configured for continuous-tone (non-screened) output.
Plate Verification
This halftone output mode is used to verify the linear response
of plates produced by a particular plate line (consisting of the
computer-to-plate device, plate processor setup, and
chemistry), with a selected screening system. When this option
is selected, the following results occur:
●
Only the
plate calibration curve
, determined by the selections
from the
Plate Setup
and
Plate Line
lists, is applied to input
tints of all separations.
●
No print calibration curve is applied.
When this option is selected, the
Plate Setup
list contains all
ColorFlow plate setups in the selected snapshot, and the
Plate
Line
list contains all ColorFlow plate lines controlled by the
selected plate setup in the selected snapshot.
When this option is selected, the
Color Setup
,
Device
, and
Device Condition
lists are not available.
This option is not available when a process template is
configured for continuous-tone (non-screened) output.
Plate Characterization
This halftone output mode supports imaging and measuring the
uncalibrated (or intrinsic) response of a plating line, such that a
plate linearization curve can be computed. When this option is
selected, no calibration curves are applied to input tints of any
separations.
When this option is selected, none of the lists in the
ColorFlow
section are available.
This option is not available when a process template is
configured for continuous-tone (non-screened) output.
Allow undefined color setup or color setup mismatch
This check box enables the job to run when the selected color
setup differs from the color setup assigned by the refine
process, or if the color setup has not been defined. Note that
436
Chapter 12—Outputs
